My PC that ran and managed 7 or 8 security cameras recently gave out so I built a new pc because it was a very old pentium 4 and i had some spare parts from a newer PC. The problem is, I can't determine what program i need or what drivers i need to run the DVR board.
Here are some obstacles I ran into:
- I tried calling the shop that did the initial set-up of the security system but they were not helpful.
- The boot drive in the old PC is dead so there is no way of looking up any information there. Though it wouldn't have been of any use because I remember the DVR software did not have any information about the product or the company; just a mere SDVR.exe
- The DVR card itself does not have any information on the PCB
However, I did some research and found out that my card is infact a counterfeit version of the Eyemax DVB9120 board (Or so I think, based on the picture from their website,http://www.eyemaxdvr.com/
, which looks identical to my DVR card).
I would greatly appreciate anybody with any experience setting up pc-based DVRs who and can guide me in the right direction. Or any information will be helpful.