C cdawg In Runtime Messages 118 Feb 19, 2014 #1 I have an haf x full tower case and I have it sitting inside my desk like this There is no fans on either side and the fan that's in the back is completely open I was wanting to know if this is sufficient enough for airflow thanx
I have an haf x full tower case and I have it sitting inside my desk like this There is no fans on either side and the fan that's in the back is completely open I was wanting to know if this is sufficient enough for airflow thanx
B BK_123 Golden Master Messages 7,578 Location Australia Feb 20, 2014 #2 I would take that piece of wood off the side or cut it down a bit to allow for better airflow on the side of PC..
I would take that piece of wood off the side or cut it down a bit to allow for better airflow on the side of PC..
ssc456 Fully Optimized Messages 4,280 Feb 20, 2014 #4 Is it enough airflow. . . . . well put some temp monitoring software on it and see. Put it thoruhg a stress test and monitor. Chances are it's fine.
Is it enough airflow. . . . . well put some temp monitoring software on it and see. Put it thoruhg a stress test and monitor. Chances are it's fine.
OP OP C cdawg In Runtime Messages 118 Feb 20, 2014 #5 I did leave 1 important part out but it also has 2 200mm fans on top and the clearance between the top of the case and the desk is 2 1/2 inches
I did leave 1 important part out but it also has 2 200mm fans on top and the clearance between the top of the case and the desk is 2 1/2 inches
jmacavali Fully Optimized Messages 4,867 Feb 20, 2014 #6 As it's been said, just put a temp monitor program on and watch it.