jamieoliver22
In Runtime
- Messages
- 245
Hi all,
I have noticed that if I type in my IP address in my browser (HTTP/80), it loads up my router's managment page. I have checked my settings and it says that remote management is not enabled and it shows that it usually goes through port 8080 anyway. So whats going on?
How can I stop this page from showing when anyone enters my IP address? I do have a static IP set up to allow with port forwarding, does this make any difference? (the static IP goes to 192.168.0.2 whereas the settings page is on 192.168.0.1)
EDIT: I think it may just be because of the static address that is set-up, so in which case it will only work on me anyway.. Shouldn't it?
Thanks,
Jamie.
I have noticed that if I type in my IP address in my browser (HTTP/80), it loads up my router's managment page. I have checked my settings and it says that remote management is not enabled and it shows that it usually goes through port 8080 anyway. So whats going on?
How can I stop this page from showing when anyone enters my IP address? I do have a static IP set up to allow with port forwarding, does this make any difference? (the static IP goes to 192.168.0.2 whereas the settings page is on 192.168.0.1)
EDIT: I think it may just be because of the static address that is set-up, so in which case it will only work on me anyway.. Shouldn't it?
Thanks,
Jamie.