Output PocketPC to a projector

[BrianS]

I don't know if this is possible but I do know this is the place to find out because someone will know.

At work, we use a HP PoketPC (HP iPAQ hx2495 Pocket PC to be specific)
http://www.shopping.hp.com/product/...Hvp1SLnfjLNRT8ynBF0Jn26jVC256yylps!-367024394

Currently, while at trade shows, we take the output of the PPC and send that into a computer. Then from the computer we output that to a projector (Dell 1201MP DLP Projector).
http://configure.us.dell.com/dellstore/config.aspx?c=us&cs=04&kc=6W300&l=en&oc=1201mp&s=bsd

What we want to do is cut out the use of the laptop but Im not sure if it is possible. Any ideas?

 

[ssc456]

ummm ... this what u want ? http://pocketpccentral.net/dispadps.htm

i dont know if that will work but i do know its possible

 

[BrianS]

unfortunately, I don't think that is going to work for me. The CF and SD slots on the PPC are being used for our application, I need to find something that runs off the bottom which is the standard USB cradle plug.

I am just going to have to keep looking.

 

[hascet]

http://h10025.www1.hp.com/ewfrf/wc/document?docname=bpj07877&lc=en&cc=us&dlc=&product=214205

Check that out, it may help you.

 

[BrianS]

That would work, but the "VGA-out PC"card" is going to slide into the CF card slot and that is being used by a Socket IO card that comes from a circuit board. Getting close though.

Thanks for all your help. This is by far the greatest computer forum on the intertubes.