Go Back   Computer Forums > General Computing > Hardware
Click Here to Login
Join Computer forums Today

Thread Tools Search this Thread Display Modes
Old 08-30-2011, 01:57 AM   #1
Beta Member
Join Date: Nov 2010
Posts: 4
Default New Build: No Display, No beeps

First off: yes, I'm aware that this problem has been asked a thousand times. I've searched for the answer already for about 5 hours and read/tried every response. Also my situation is slightly different. Anyway, here goes...

Building a new computer, here are the specs:

Intel Core i7 2600k
Asus P8Z68-V Pro
16 GB Corsair Vengeance LP
Samsung Spinpoint F3
Corsair AX850W
Cooler Master Hyper212+
Cooler Master Haf X

I also have a working disc drive and a Radeon HD6970 that I've uninstalled for now to limit the number of possible problems (since the mobo has onboard video).

So I install everything, plug all the cables in (and yes, both the 24-pin and 8-pin PSU to board cables are firmly in place), and start it up. It dies the first time but I assume that's just a problem with its first boot, so I start it again and this time it runs with no problem. I let it run for 2 minutes and then shut it back down to move it to the room where it's going to be set up. Here I plug everything in: the speakers, wireless mouse, keyboard, and monitor. Again I start it up, it runs for maybe 8 seconds, shuts down, and then starts up again on its own. Once it starts again it runs for good, but there is no display on the monitor. I swap out a different monitor as well as trying with the tv and all are exactly the same.

Everything in the case is being powered: multiple case fans, the cooler fan, the GPU fan was spinning when I had it installed, the disc drive opens and if I put a disc in it spins the disc. The only fan not spinning is on the Power Supply; it spins for a second when I first power it up and then stops, as well as spinning for a second when I power it down. Should this fan be spinning normally or only when it gets to high temps?

On this motherboard there are LEDs which are supposed to indicate where there may be a potential problem. I notice that the DRAM LED is constantly lit, so I take out all the RAM and try them one by one in the A1 slot as well as a couple in the B2 slot. There is no change, it boots up for a few seconds, shuts down, comes back on and runs still with the LED on and no display. I tried pressing and holding the MemOK! button for 3 seconds, which makes the LED blink for a couple seconds, shuts off the computer, turns it back on with more blinking, shuts it off again after a little bit, back on with faster blinking before eventually leaving it back on with just a steady red light again and still no display. I tried removing all the RAM and starting it, this time it boots up for half a second before shutting off, then restarts on its own after a couple seconds and runs for good, still with the LED on. I didn't notice any distinctive beeps outside of the normal sounds of a computer starting up, I do have normal computer speakers hooked up and on but I'm not sure that works?

That's about all I've got. I'm not certain if the hard drive is spinning or not but it really shouldn't matter for at least getting to BIOS. So I have no idea what the problem is or what to do now, I'm going to have a hard time convincing the store I bought the RAM from that all 4 sticks are bad, which I somewhat doubt myself, but I'm not sure what else to try. Help? Thanks in advance.

Hari is offline   Reply With Quote
Old 08-30-2011, 08:26 AM   #2
In Runtime
medabomb2000's Avatar
Join Date: Jun 2005
Posts: 271
Send a message via AIM to medabomb2000
Default Re: New Build: No Display, No beeps

First let me ask, have you tried only using one of the memory stick by itself? I would attempt to try to use only one of them at a time. Try each stick to see if that LED light goes away. I have the same mobo and I did notice that when I first installed my memory sticks that I had to reset them into the slots to make sure they had a good connection. Let me know if this changes the LED light.
PSU:OCZ 600W modular - Mobo:ASUS P8Z68-V PRO - Processor:Intel Core i7-2600K - CPU Coolant:ZALMAN CNPS11X Extreme - Memory:CORSAIR Vengeance 8GB DDR3 1866 - Hard Drive:4.0 TB [2]Seagate Barracuda XT 7200 RPM SATA 6.0Gb/s - Video Card:NVIDIA GeForce 7950 GT 512mb - DVD Drives:Sony 18x DVD+/- DL Burner and Samsung 18x DVD+/- DL Burner - OS: Windows 7 Ultimate 64-bit
medabomb2000 is offline   Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

All times are GMT -5. The time now is 09:15 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.6.0