Motherboard screwing in

[jashan17]

When im screwing in my motherboard... Some screws dont go in tightly. I already have like 4 or 5 in tight. Should i just not screw in those ones?

 

[jashan17]

Guys?

 

[A True Folder]

have you stripped the threads in the risers?

are there risers under the the board where you're trying to screw in screws?

Can you post a pic of your board with which screws are in and which won't tighten?

What cpu cooler are you using? (it will have a bearing on which screws are OK to leave out)

 

[jashan17]

have you stripped the threads in the risers?

are there risers under the the board where you're trying to screw in screws?

Can you post a pic of your board with which screws are in and which won't tighten?

What cpu cooler are you using? (it will have a bearing on which screws are OK to leave out)

Yeah two of the ones that dont screw in have risers in them.. The screws i screwed in were too big and when i pulled them out the riser was stuck on the screw... Its no big deal, theres just a little gap there now..

 

[borat_sagdiyev]

use the right type of screw?

 

[Kage]

I did the same thing beleive it or not, when fitting mine.
Luckily for me, the right screws still screwed in tight, with a little push.
Make sure the board is touching the riser, and then try to do it again.