GhostGT
Daemon Poster
- Messages
- 1,019
Just finished building the sister's rig, and fired it up and all started up successfully. HOWEVER, I was keeping my eyes out for the heatsink (Freezer Pro Rev 2) and the fan on the heatsink wasn't spinning. So I immediately shut down the system.
Is this normal? Should the fan start spinning immediately or are there settings I have to change?
(The fan itself is plugged into the slot labeled (CPU FAN).
UPDATE:
I switched the connector to the SYS FAN1, and it is working now. Will update again.
Is this normal? Should the fan start spinning immediately or are there settings I have to change?
(The fan itself is plugged into the slot labeled (CPU FAN).
UPDATE:
I switched the connector to the SYS FAN1, and it is working now. Will update again.