Case swap

[Sharpy1]

It's a oem board from an Acer aspire m3201 the board is acer rs780hvf and could be difficult trace them

Sent from my SM-A500FU using Computer Forums mobile app

 

[Sharpy1]

Can we also confirm that this board is deffinitly micro ATX and will fit into that case

http://img.alibaba.com/img/pb/073/832/241/1271047577973_hz_fileserver1_597388.jpg



Sent from my SM-A500FU using Computer Forums mobile app

 

[crazyman143]

It's definitely standard micro atx.

 

[Sharpy1]

Thanks again crazyman I know you already told me that on the older post

How can you tell the difference between the different standards

Sent from my SM-A500FU using Computer Forums mobile app

 

[crazyman143]

I can usually just tell by the layout and the location of screw holes. Take a look at this:

 

[Sharpy1]

Yh there's just one screw hole missing for micro ATX the very bottom hole by the left looks like there a heatsink in the way but either way It will fit into the case even if I can't use all the mounting holes

Have you got any thoughts on the case header

Sent from my SM-A500FU using Computer Forums mobile app

 

[crazyman143]

Like technician said, since it's not printed on the board which pins are which, easiest way is to probably just follow the wires on the current case to see whats what, then connect the new header accordingly. It might take some trial and error to get them right.

 

[Sharpy1]

If I got the places wrong would i damage my board

Sent from my SM-A500FU using Computer Forums mobile app

 

[crazyman143]

I hesitate to say impossible. But I'd say unlikely since it's all low voltage LEDs and buttons.

 

[Sharpy1]

Ok thanks on all the help on that if I get any problems once I buy the case I. Will let you all know

Sent from my SM-A500FU using Computer Forums mobile app