First Boot Issues

[Remeniz]

Please reset defaults in BIOS and try again.

That or in the BIOS head to 'Advanced BIOS Features' > 'Chipset Features' and enable 'Hybrid SLI Support'. F10 to save.

 

[KoolAidMan888]

How do i compltey start over? like make it so its the virst time the comp started? wat do i reset inside the comp?

nvm that last one.... The Hybrid SLi is already enabled

 

[Remeniz]

You can clear the CMOS by shorting the JBAT jumper pins 2-3 while the system is off. This will reset the CMOS settings.

 

[KoolAidMan888]

yea i did that im trying to tlk to some one who speaks English from windows tech center

just saw this

Will these work??
http://www.newegg.com/Product/Product.aspx?Item=N82E16820231303
http://www.newegg.com/Product/Product.aspx?Item=N82E16813130236

 

[Remeniz]

yea i did that im trying to tlk to some one who speaks English from windows tech center

just saw this

Will these work??
http://www.newegg.com/Product/Product.aspx?Item=N82E16820231303
http://www.newegg.com/Product/Product.aspx?Item=N82E16813130236

Thats what you have already.

With Hybrid SLI enabled you have to use the monitor output on the motherboard.

Disable Hybrid SLI and use the output on the graphics card.

EDIT: I'm sifting through the manual for the motherboard...

Try disabling the Hybrid SLI feature.

And take a look at OCSWITCH1. Make sure switches 1 and 2 are 'on' for the default setting.

 

[KoolAidMan888]

Yea those are the ones i have.. Ill try the last thing you said.. im thinking the ram i have wont work if u look at the features it gives its made for a intel board... The ones i need are red not blue.. Ill give wat you said a try... Thank you

 

[Remeniz]

...im thinking the ram i have wont work if u look at the features it gives its made for a intel board... The ones i need are red not blue..

Although they 'say' the RAM is made for Intel boards it will work with AMD boards...

You just might have to enter the BIOS and set the RAM settings/timings manually.

This could be somewhere to look maybe. If the RAM settings/timings are all wrong in the BIOS this can give you a black screen when it tries to load the OS as the system can't utilise the RAM properly. Go into the BIOS and check the RAM settings. The speed should be @ 1600Mhz or less although a little over 1600Mhz is ok. But the timings should be 7-8-7-24-2.

 

[KoolAidMan888]

ok i tried a older hard drive and it booted up with np

Im Still Stuck At The Starting Windows Screenn... Wtf

 

[Remeniz]

Im Still Stuck At The Starting Windows Screenn... Wtf

Give it 10-15 minutes then you'll get the install options.

Be very patient!