R ringtemek Daemon Poster Messages 684 May 22, 2010 #1 I have a old remington pl-4 chainsaw and it doesn't have a good enough spark for the engine to start. Is there a way to replace/fix the armature and coil currently in it
I have a old remington pl-4 chainsaw and it doesn't have a good enough spark for the engine to start. Is there a way to replace/fix the armature and coil currently in it
Atomic Rooster Omnipotent One Messages 11,161 Location USA May 22, 2010 #2 You should be able to take it apart and clean everything up with some emery cloth to remove any oxidation that may be holding it back.
You should be able to take it apart and clean everything up with some emery cloth to remove any oxidation that may be holding it back.
OP OP R ringtemek Daemon Poster Messages 684 May 22, 2010 #3 do you know how to take off the armature and coil
OP OP R ringtemek Daemon Poster Messages 684 May 25, 2010 #4 how would i test the armature & coil with a multimeter
OP OP R ringtemek Daemon Poster Messages 684 May 25, 2010 #6 i tried that, i also cleaned everything(contacts, condenser, etc)