I bought a sparkle 8400GS to use in a low profile application. The card comes from the manufacturer with the IO shield attached and all three ports on the card, DVI, S out and then off to the side, remotely located with a ribbon is the analog. I need to use the analog as a low profile setting. NO problem it would SEEM because the card also comes with two low profile IO shields to replace the regular one. One is shaped for the DVI and the S out, the other is shaped for the analog and the S out. The problem? The DVI appears to be soldered to the board, at least it looks that way. I can't figure out how I would replace the DVI with the analog to put the shield on.