Zer0Cool
Fully Optimized
- Messages
- 1,599
Yesterday I finally put everything in my case and fired up the system, and it worked! lol
This is my first build and I'm a total noob when it comes to bios…etc I have a Q9450 that ha an 8X but the system showed it as 6X and my speed was 2.0 instead of 2.6 anyone know why it would do that? I changed the X to 8 and I gat my stock speed of 2.6.
I was looking at “PC Health†in bios and I had 20c for my CPU and 47C for my PWN/Chipset and this was a totally fresh install, no OS installed. B4 assembling everything I decided to take off the motherboard heatsink and re apply the thermal paste for better results, but 47c looks high to me, what u think? I also will be doing overclocking so this temp will go even higher. I know that it will take a few days for the thermal paste to sink in…etc but still. My MOBO is “DFI LP UT P35â€
http://www.newegg.com/Product/Product.aspx?Item=N82E16813136037
So what u guys think? Should I worry about this? Here is a pic of some of my volts…etc Keep in mind that the temp for PWN/Chipset was 47c
By the way can someone please tell me where is the north bridge and the south bridge on my mobo? The pwn is next to my IO shield I know that.
Thanks
This is my first build and I'm a total noob when it comes to bios…etc I have a Q9450 that ha an 8X but the system showed it as 6X and my speed was 2.0 instead of 2.6 anyone know why it would do that? I changed the X to 8 and I gat my stock speed of 2.6.
I was looking at “PC Health†in bios and I had 20c for my CPU and 47C for my PWN/Chipset and this was a totally fresh install, no OS installed. B4 assembling everything I decided to take off the motherboard heatsink and re apply the thermal paste for better results, but 47c looks high to me, what u think? I also will be doing overclocking so this temp will go even higher. I know that it will take a few days for the thermal paste to sink in…etc but still. My MOBO is “DFI LP UT P35â€
http://www.newegg.com/Product/Product.aspx?Item=N82E16813136037
So what u guys think? Should I worry about this? Here is a pic of some of my volts…etc Keep in mind that the temp for PWN/Chipset was 47c
By the way can someone please tell me where is the north bridge and the south bridge on my mobo? The pwn is next to my IO shield I know that.
Thanks