Over Clocking Screeny

[Liminator]

Yeah I don't have that but what about CPU/DDR Clock Ratio?

It's currently at 2/2. On the screeny its right below DDR Clock/Timing Mode.

 

[The Amish Kid]

Try using 5/6 or 6/5. Agian you may not have to do this unless you are raising your fsb pretty high. If its value memory you will probably need a divider past a 205mhz fsb.

 

[Liminator]

Well I overclocked a bit and I got these results.

http://putfile.com/pic.php?pic=6/16416100679.jpg&s=f5

This gives me about 1847MHz compared to 1808 MHz from before.

At about how fast should I change the CPU/DDR Clock Ratio?

Oh yeah, any suggestions for checking stability?

Thnx in advance.

 

[mammikoura]

to check if it's stable or not download a program called prime 95. Let it run for some time (just like 5-10 minutes) once in a while (say like every 200mhz) and if there is no errors then it's ok. Then when u have finished oc'ing let prime 95 run for like 10h to make sure that it's 100% stable.

 

[The Amish Kid]

I would think you would need to start using a divider pretty soon to keep it stable. But just keep raising it 5-10mhz see how far you can get.

For stability what mammikoura said Prime95 works good. You can also use SuperPi which is good for quick testing.

 

[Liminator]

I'm still not sure how to get a memory divider though.

My MOBO is a Gigabyte Technologies K8NSC-939. Hope that helps.