I am in the middle of building my new rig.... I got the CPU on so it was time to put on the heat sink... I put it on and fasten the retaining clip on one side.... i go to the other side and the other clip wont reach! i barely got it to go on.... so now when i try to close the lever on the other side... it wont close because the other side is on to tight... CPU is a AMD athlon x2 4400+ and mobo is dfi lanparty ut sli-dr expert... i have some pictures too...
http://i74.photobucket.com/albums/i255/ericm17777/DSC00582a.jpg
this is the one side of the heat sink... i barely got the retention clip to fit.....
http://i74.photobucket.com/albums/i255/ericm17777/DSC00583a.jpg
this is the other side with the lever... it wont shut since the other side is on too tight....
http://i74.photobucket.com/albums/i255/ericm17777/DSC00584.jpg
overhead view...
any ideas??? the heat sink is relatively centred so im not sure what the problem is...
http://i74.photobucket.com/albums/i255/ericm17777/DSC00582a.jpg
this is the one side of the heat sink... i barely got the retention clip to fit.....
http://i74.photobucket.com/albums/i255/ericm17777/DSC00583a.jpg
this is the other side with the lever... it wont shut since the other side is on too tight....
http://i74.photobucket.com/albums/i255/ericm17777/DSC00584.jpg
overhead view...
any ideas??? the heat sink is relatively centred so im not sure what the problem is...