Zonealarm

[alex_boothby]

I have just set up printer sharing on my comp and its great. bu then i go and turn Zonealarm back on and it wont work. and i try to tell ZA the ip and subnet of the comp shud be trusted but noooooooooo.

p.s ermmm shud the i.p of it on my netowrk be 192.168.2.3 and the subnet be 255.255.255.0, i was wandering if that is why ZA donesnt like it.

any help is helpful help.

 

[mammikoura]

the maximum lines allowed in signatures is 5, so shorten ur sig.

Not sure about the printer ip, but check the manual. And for all I know that subnet is correct.

Try this:
Open ZA's control center
Select firewall from the left
Then change the Trusted Zone Security to low (or med if u have it on high)