oh ok thanks!
upon further examination of the disk, i found a linux driver, but the instructions for use are for a floppy drive... i sort of need help on comverting them so i can use it with a cd becasue my pc does not recognize my floppy drive for some reason... i am kind of a noob at this junk, but i need to learn. here are the instructions:
**
**
** VIA Rhine Family Fast Ethernet Adapter
**
** Linux Driver
**
** v4.32 Feb. 2004
**
**
Introduction:
=============
The instructions listed below are for linux driver installation. You must
compile the source code to generate rhinefet.o and use insmod command to
insert rhinefet.o as module.
Contents of the Subdirectory:
=============================
linux.txt This file.
rhinefet.c The linux core driver source code file
Makefile Makefile for generating driver object file
rhine_vmns.c The vmns driver support source file
rhine_proc.c The source to create proc entries
rhine_wol.c The WOL supporting source file
rhine.h The extended driver header file
rhine_vmns.h The vmns driver support header file
rhine_proc.h The header file for proc entries
rhine_wol.h The WOL supporting header file
rhine_cfg.h The vmns driver support header file
vmns_drv.h The vmns driver support header file
kcompat.h The header file for Linux kernel version
compatibility.
Kernel Supported
================
This driver support linux kernel version 2.2.x and 2.4.x now.
Installation
============
Please enter the following commands at the UNIX prompt. Remember, UNIX is
case sensitive.
1) Create a temporary directory:
mkdir /temp
2) Change to the temporary directory:
cd /temp
2) Copy driver (rhinefet.tgz) from DOS disk, (mcopy below is one tool in
mtools, if you didn't install mtools, you can type
'mount -t msdos /dev/fd0 /mnt' and use 'cp /mnt/rhinefet.tgz /temp'
command to copy the driver to the temporary directory):
mcopy a:rhinefet.tgz .
3) untar the archive file:
tar xzvf rhinefet.tgz
cd rhinefet
4) Compile the driver source files and it will generate rhinefet.o, and
copy it to correct driver installation path (The installation directory
is different in different kernel versions. In 2.4.x kernel, the path is
/lib/modules/KERNEL_VERSION/kernel/drivers/net/, and in 2.2.x kernel,
the path is /lib/modules/KERNEL_VERSION/net/, the KERNEL_VERSION (see
above) means the kernel version of your Linux distribution. If you don't
know your kernel version , please run 'uname -r' command in command
line. The kernel version will look like '2.2.16', '2.4.2-2smp' etc.) :
make install
5) Check configuration file (/etc/modules.conf or /etc/conf.modules,it
depend on your Linux distribution) for loading kernel modules. Make sure
there is the following content in the configuration file, where # is
interface number (eg: alias eth0 rhinefet):
alias eth# rhinefet
6) Reboot now:
shutdown -r now
7) Install your driver module (If the driver module is in the wrong place,
an error message will appear, and say that can't find the driver
module):
insmod rhinefet
8) Use ifconfig command to assign the IP address, where # is network
interface number:
ifconfig eth# <IP>
9) Check the interface works:
ping <remote_host_IP>
i know what its basically saying, but i dont know how to convert the instructions for use with a cd drive. thanks