B bill gisse Baseband Member Messages 95 Mar 6, 2006 #1 My new homebuilt doesn't see the slave dvd-rom and floppy drives. Checked everything , replaced IDE cable. The DVD +- R/RW drive in the Master position works okay. Any suggestions.
My new homebuilt doesn't see the slave dvd-rom and floppy drives. Checked everything , replaced IDE cable. The DVD +- R/RW drive in the Master position works okay. Any suggestions.
K ~K-Pow~ Daemon Poster Messages 1,241 Mar 6, 2006 #2 Switch your slave into your master to make sure it works. If it don't you could have a bad CD-ROM.
~mr mixx~ The Candyman Messages 11,355 Location USA Mar 6, 2006 #3 Also you can go into Devise Manager and un-install it, then the next time you boot up...it should load the correct driver's for it to work.
Also you can go into Devise Manager and un-install it, then the next time you boot up...it should load the correct driver's for it to work.
joxley1990 Golden Master Messages 7,846 Mar 6, 2006 #4 Looks like a bad drive, the jumpers are set right on everything arnet they?