jdf_warrior
Solid State Member
- Messages
- 9
ok, i have 3 hard drives, an old 40gig ide, another old 13gig ide, and a 200gig sata
recently, was running windows normally and it all of a sudden started running extremely slow, and then just froze, i rebooted the machine, and got a disk boot failure error i believe is what it was, still had the 13 and 200 so i kept going and i ordered a new 160gig ide maxtor drive, within a week, before the new drive came in, the 13gig died too, or it appeared to, i havent fully checked them, wanted a new drive anyway, seemed like a godo excuse, but anyway, i have the 160gig and the 200gig drives now and i have only had the 160 for about a week or so, and i was in windows yesterday and hit the same problem, it seemed as if windows almost quit responding, finally rebooted, and disk boot failure.. but if i booted with an XP boot disk, it still reads the drive, so its not dead. i eventually, after alot of piddling with it, finally got it formatted and running, ghosted windows back to the drive, it ran all afternoon and night, woke up this mornin, looking at a disk boot failure message again. i've tried different ide cables, and tried swapping the drive from the primary ide channel to the secondary channel and still have the same result.
any ideas of whats going on? any ideas of something i can try to figure it out? i was thinking it could be the channel on the MB going bad, but its only a few months old, i just got it in like january.. someone else suggested a power supply issue, it not being strong enough to run everything, but it was running before with 3 drives and 2 cdroms and everything else, since all this started happening, ive been running 1 hdd and 1 cdrom and still have the same problem.. and i dont particularly want to buy a new motherboard if thats not the problem, because if i do i might as well upgrade and get one with pci-e, which in turns means i'd be buying a new video card as well
recently, was running windows normally and it all of a sudden started running extremely slow, and then just froze, i rebooted the machine, and got a disk boot failure error i believe is what it was, still had the 13 and 200 so i kept going and i ordered a new 160gig ide maxtor drive, within a week, before the new drive came in, the 13gig died too, or it appeared to, i havent fully checked them, wanted a new drive anyway, seemed like a godo excuse, but anyway, i have the 160gig and the 200gig drives now and i have only had the 160 for about a week or so, and i was in windows yesterday and hit the same problem, it seemed as if windows almost quit responding, finally rebooted, and disk boot failure.. but if i booted with an XP boot disk, it still reads the drive, so its not dead. i eventually, after alot of piddling with it, finally got it formatted and running, ghosted windows back to the drive, it ran all afternoon and night, woke up this mornin, looking at a disk boot failure message again. i've tried different ide cables, and tried swapping the drive from the primary ide channel to the secondary channel and still have the same result.
any ideas of whats going on? any ideas of something i can try to figure it out? i was thinking it could be the channel on the MB going bad, but its only a few months old, i just got it in like january.. someone else suggested a power supply issue, it not being strong enough to run everything, but it was running before with 3 drives and 2 cdroms and everything else, since all this started happening, ive been running 1 hdd and 1 cdrom and still have the same problem.. and i dont particularly want to buy a new motherboard if thats not the problem, because if i do i might as well upgrade and get one with pci-e, which in turns means i'd be buying a new video card as well